Hello Guest it is March 28, 2024, 10:46:16 AM

Author Topic: reversing slaved stepper direction on gantry router???  (Read 2958 times)

0 Members and 1 Guest are viewing this topic.

reversing slaved stepper direction on gantry router???
« on: April 11, 2008, 02:33:36 PM »
Hello Everyone,

Well after spending 3 days searching for what was causing Mach Version 2.61 to act crazy after having worked great for months, someone recommended that I redo the config in a new file.

I did that and now everything works, except I cannot find the box to check for reversing the A axis stepper motor direction that is slaved to the Y axis... the motors are going in opposite directions on the gantry...

I went through the manual and it says to goto config/ motor reversals...BUT that tab is not listed under my config options.

Any help will be GREATLY APPRECIATED!!!

Best Regards,

Preston pulling out my hair >:(
« Last Edit: April 11, 2008, 02:35:15 PM by PJEnge »
Re: reversing slaved stepper direction on gantry router???
« Reply #1 on: April 11, 2008, 02:43:09 PM »
Config menu > Homing/Limits

Monte
Re: reversing slaved stepper direction on gantry router???
« Reply #2 on: April 11, 2008, 02:45:17 PM »
THANK YOU MONTE!!!!!!!!

Best Regards,

Preston

Config menu > Homing/Limits

Monte