Let me know if there are any problems or suggestions.
Just hit any bottom button a second time and the MPG will pop out.

Looks great Chucky, nice.

Brett

thx

Nice work looks great..great colors..easy on the eyes..can see from far away..nice 

Updated the file at bottom of post #1

Changed the point to point screen
 Added feed for x,y and separate one for z
 Added drill and peck

Changed some button codes

The drill stuff will not work with the new Version R3.038 for some reason. --Edit works fine with Version R3.039 now

 

Hello,

this is super work, thank's

Fabrice

Chuck, you're an artist, my friend and this is a wonderful screen set, thanks so much for your hard work 

Thank you


Here is an update set that gives the point to point screen a whole lot more help, status and info while things are running.

Rename the file to Chucks.set 

EDIT See below for file

This new set will only use x,y feed rate below 0.0000 Z-axis for milling and 100% for moving above 0.0000.

Edit see blow for DL file

This point to point update has 2 basic modes

Auto – when you first open it will.
Turn on the spindle and wait for coolant to prime and use feed rate any time you move and below 0.0000 on the z-axis for all axis.
When you are above 0.0000 z-axis it will use rapid rate for all axis moves.
If you move the z-axis from a +number to a  - number it will go to .120 stop turn on spindle wait for coolant to prime then cut.
Any z-axis move up will use rapid rate.

Manual – hit the manualbutton will.
No matter what move you make they will always move at the rate you set with no spindle stuff.

I also added the ability to set the x and y axis separately for each of the 9 points and more status info.