Machsupport Forum
Mach Discussion => Mach Screens => Finished Screens => Topic started by: chucky on March 18, 2008, 08:29:30 PM
-
Let me know if there are any problems or suggestions.
Just hit any bottom button a second time and the MPG will pop out.
-
Looks great Chucky, nice.
Brett
-
thx
-
Nice work looks great..great colors..easy on the eyes..can see from far away..nice :)
-
Updated the file at bottom of post #1
Changed the point to point screen
Added feed for x,y and separate one for z
Added drill and peck
Changed some button codes
The drill stuff will not work with the new Version R3.038 for some reason. --Edit works fine with Version R3.039 now
-
:o
Hello,
this is super work, thank's
Fabrice
-
Chuck, you're an artist, my friend and this is a wonderful screen set, thanks so much for your hard work :)
-
Thank you
Here is an update set that gives the point to point screen a whole lot more help, status and info while things are running.
Rename the file to Chucks.set
EDIT See below for file
-
This new set will only use x,y feed rate below 0.0000 Z-axis for milling and 100% for moving above 0.0000.
Edit see blow for DL file
-
This point to point update has 2 basic modes
Auto – when you first open it will.
Turn on the spindle and wait for coolant to prime and use feed rate any time you move and below 0.0000 on the z-axis for all axis.
When you are above 0.0000 z-axis it will use rapid rate for all axis moves.
If you move the z-axis from a +number to a - number it will go to .120 stop turn on spindle wait for coolant to prime then cut.
Any z-axis move up will use rapid rate.
Manual – hit the manualbutton will.
No matter what move you make they will always move at the rate you set with no spindle stuff.
I also added the ability to set the x and y axis separately for each of the 9 points and more status info.
-
Nice screen Chuck...good job.
I like the way it's similar to looking at the screen of a traditional CNC like Fanuc or Fagor etc etc
Darc
-
thank you :D