Hello Guest it is March 28, 2024, 06:52:50 PM

Author Topic: missing steps???!  (Read 3012 times)

0 Members and 1 Guest are viewing this topic.

missing steps???!
« on: March 18, 2008, 12:15:39 PM »
Hi,

I don't know if this is the right term, but I am just about done with an installation (retrofit of a Shizouka cnc knee mill using the original steppers), and sometimes when I run a rapid using mdi mode, my x axis motor just 'whines' -makes a higher pitched noise than usual and just sits there.  I have 14 thou of backlash which I know I need to fix.  Usually, it doesn't have any problem, and it is the only axis for which I have programmed backlash.  The Y axis is set to the same motor tuning parameters. 

I am using Gecko 203V's.

Any Ideas?

Thanks.

Bill

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: missing steps???!
« Reply #1 on: March 18, 2008, 04:20:54 PM »
Hi, Bill

Reduce the Velocity and Acceleration some for the X axis, Velocity is used as your top Feed-rate Rapid G00 moves.

Have you checked the Gecko's manual for jumpers and adjustment's for large steppers.

Hope this Helps, Chip
Re: missing steps???!
« Reply #2 on: March 18, 2008, 11:27:00 PM »
I'll give it a try.

Thanks,

Bill