Hello Guest it is March 28, 2024, 07:22:04 PM

Author Topic: Feed Rate Errors  (Read 3327 times)

0 Members and 1 Guest are viewing this topic.

Feed Rate Errors
« on: May 02, 2006, 07:13:35 PM »
Mach 2 will radius an angle cut when the feed rate is to high on our plasma cutter. How do I prevent this from happening without slowing the feed rate down? Does Mach 3 have this same problem?
Re: Feed Rate Errors
« Reply #1 on: May 02, 2006, 08:06:34 PM »
That is the CV (G64) try putting it in Exact stop (G61)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com