I have just purchased this software add on. I like what I see so far. However, a couple of things.
1) I can find no reference to G40.1 (I am a$$uming it should be G40 that should be generated), if not, someone please tell me what G40.1 is. (I am also quite new to CNC programing).
2) I am using Mach3 as supplied by Tormach for PCNC1100. There is still at least one issue where the hard coded path to Mach3 is used. When I use the List operations button on the main
screen I get, Error on line:19 - The system cannot find the path specified. If I edit the script that pops up to point to the PCNC3 directory and then 'run', things perform properly.
P.S. It would be help full if errors could be forced to the top. I have had what seemed to be a hang situation only to find that there was an error box behind the main screen
that needed to be responded to.
Regards
Rick G.