Hello Guest it is April 19, 2024, 03:08:31 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: jerky servo Mach3  (Read 7239 times)

0 Members and 1 Guest are viewing this topic.

Offline Ed

*
  • 15 15
    • View Profile
Re: jerky servo Mach3
« Reply #10 on: February 11, 2008, 11:46:29 AM »
This is my xml file.
Thanks
« Last Edit: February 11, 2008, 01:57:43 PM by Ed »
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: jerky servo Mach3
« Reply #11 on: February 11, 2008, 04:29:47 PM »
Ed
looked through your xml and dont see anything wrong. Did notice you had different steps per unit for each axis though, is this correct?
Hood
Logged

Offline Chip

*
  • *
  • 2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: jerky servo Mach3
« Reply #12 on: February 11, 2008, 04:45:25 PM »
Hi, Ed

Mach may be trying to adjust your vel/Accl. when your setting dif. kernel speed's back and forth, A re-start is req. after change and then a Re-tune of vel/Accl.

Did you use g00 moves or Shift + Arrow key to tune your Velocity & Acceleration settings ?

On the Program Run Screen what's your Feed-rate set to ?, Hit the TAB key, What's the Slow-Jog Rate set to ?

If thy aren't set to 100 then your tunning is probably way off.

It's volunteer's around hear for the most part.

Hope this Helps, Chip
Logged
Pages: « 1 2   Go Up
« previous next »