Hello Guest it is August 03, 2020, 11:18:38 PM

Author Topic: Pocketing Problems  (Read 1067 times)

0 Members and 1 Guest are viewing this topic.

Pocketing Problems
« on: August 21, 2016, 03:32:27 PM »
Well back again with more of the same problems.

After 2 weeks of replacing bearings , squaring up the machine and adjustments after my machine mysteriously went off the job dimensions and into my clamping system I finally have been running test pieces.

Thought I had everything pretty good.  I decided to try a Vcarve Inlay since I finally got them working after months before this collapse.

The machine just kept going around the same first pocketing cut , a complete loop from inside the vector but never moving outwards to take out/pocket more material.  It runs an initial loop and just keeps repeating over and over in the same pattern.

All my settings are the same, I did not mess with anything.  I looked at stepover and it is the same as always in which I have had success before.

I am using Aspire 8.5 and Mach3


Anyone ever have this problem before?

TIA

Offline Tweakie.CNC

*
  • *
  •  8,386 8,386
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Pocketing Problems
« Reply #1 on: August 22, 2016, 01:32:57 AM »
If you attach you Gcode file it can be tested.

Tweakie.
KEEP SAFE !