Hello Guest it is March 28, 2024, 04:42:46 AM

Author Topic: drill holes  (Read 2085 times)

0 Members and 1 Guest are viewing this topic.

drill holes
« on: February 01, 2008, 08:28:39 AM »
Am I right in assuming that 'Drill Sel Circles' and 'Drill Rad Circles' are buttons to produce Can Cycles? ie select some circles then pressing the first button will produce G code for a can cycle, set a minimum radius in the second button and all circles below that will produce can cycles?
If so I can't get it to work, trying on two different computers.
I get "Debug Assertion Failed line 288" If I press 'retry' I am lucky if the programme just shuts down. On one occasion the computer froze, requiring a mains disconnection.
The message on 'retry' is "Unrecoverable error in ENDGLDRAW1"
Any pointers?