Machsupport Forum
G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: dhookings on February 01, 2008, 08:28:39 AM
-
Am I right in assuming that 'Drill Sel Circles' and 'Drill Rad Circles' are buttons to produce Can Cycles? ie select some circles then pressing the first button will produce G code for a can cycle, set a minimum radius in the second button and all circles below that will produce can cycles?
If so I can't get it to work, trying on two different computers.
I get "Debug Assertion Failed line 288" If I press 'retry' I am lucky if the programme just shuts down. On one occasion the computer froze, requiring a mains disconnection.
The message on 'retry' is "Unrecoverable error in ENDGLDRAW1"
Any pointers?