Hello Guest it is March 28, 2024, 06:16:45 PM

Author Topic: Look ahead above 2 can cause G0 Feed-hold/Cycle Start Issues Position Loss  (Read 4257 times)

0 Members and 1 Guest are viewing this topic.

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Hi, All

Mach3R3.01 is on line, It Has a couple of Issue's.

Wait till tomorrow, When this Msg. is Deleted or Edited to download.

Yahoo mach1mach2cnc group is down at the moment, Posted some info for Brian just before it went down.

In the install location has a space between the C:\Mach 3 should be C:\Mach3.

I now in the past there has been a install path C:\Mach3R183.##.... that had to be edited to Mach3 sometimes.


Mach3R3.01 has a fix for a feedhold problem, There seems to be an Issue with position after a feed hold In G0 move,

It's losing position on next Cycle Start.


Thanks, Chip
« Last Edit: January 08, 2008, 02:42:00 PM by afn09556 »
Chip,
I have fixed the install program and I will work tonight on the code to fix the feedhold. That, I think is going to take the night and I am not sure that I wil be able to finish it :(

Thanks
Brian
« Last Edit: January 08, 2008, 02:42:58 PM by afn09556 »
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Chip send me your Gcode file please... I can not seem to get the same problems.

thanks
Brian
« Last Edit: January 08, 2008, 02:43:23 PM by afn09556 »
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Hi, Brian

Was up late last night till 5:00am

Hears the code

Thanks, Chip
« Last Edit: January 08, 2008, 02:43:48 PM by afn09556 »

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Hi, Brian

After looking at this further, Look ahead above 2 can cause G0 Feed-hold/Cycle Start Issues  Position Loss.

Seems to skip cuts or double cut them. Hears a picture with 3 in look-ahead

Thanks, Chip
« Last Edit: January 08, 2008, 06:49:15 PM by afn09556 »