Barker806,
When you say it looks good do you mean that the CPU and Mach 2 are working properly? Are there any other ways for me to trouble shoot this problem?
Do you think it might be an issue with the motor tuning settings? The setup I used for each axis is as follows:
Velocity 0.5
Units / sec^2 = 4
Steps per unit = 20000
Kernel speed set at 35000 Hz
Theorectically, with the system flat out the maximum Velocity should be 1.75 inches/second or 105 inches per minute. To be conservative I limit the rapid movements to 30 IPM. Do you have any thoughts on this?
Steve