Hello Guest it is December 10, 2019, 07:05:23 PM

Author Topic: Trying to upgrade  (Read 3461 times)

0 Members and 1 Guest are viewing this topic.

Offline olf20

*
  •  318 318
    • View Profile
Trying to upgrade
« on: January 07, 2008, 04:55:21 PM »
Hi all!
I downloaded the current lock down release R3.01. When trying to install, the install will stop and give me this error. "Can not continue install because file "dxfreader.ocx" can not be found.
I double checked my Mach3 folder and this file is present. I tried the install / upgrade several times but the same error occurs.
I'm installing this in the same folder / drive that I have always used for prior upgrades.
Any help will be appreciated!
Thanks olf20
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998

Offline Hood

*
  •  25,856 25,856
  • Carnoustie, Scotland
    • View Profile
Re: Trying to upgrade
« Reply #1 on: January 07, 2008, 05:31:00 PM »
Not tried it myself but will do so in a few mins, did you try re downloading it from the site just in case you got a corrupt download?
Hood

Offline Hood

*
  •  25,856 25,856
  • Carnoustie, Scotland
    • View Profile
Re: Trying to upgrade
« Reply #2 on: January 07, 2008, 05:37:08 PM »
olf20
where are you getting 3.01 from? I only see 3.00 on the downloads page.
Hood

Offline olf20

*
  •  318 318
    • View Profile
Re: Trying to upgrade
« Reply #3 on: January 07, 2008, 06:10:16 PM »
Sorry typo, it is 3.00. I just redownloaded the lockdown version. Tried to reinstall but same error.
Thanks olf20
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998

Offline Hood

*
  •  25,856 25,856
  • Carnoustie, Scotland
    • View Profile
Re: Trying to upgrade
« Reply #4 on: January 07, 2008, 06:19:06 PM »
Strange, i have just installed 3 to try again and it works fine.
Hood

Offline olf20

*
  •  318 318
    • View Profile
Re: Trying to upgrade
« Reply #5 on: January 09, 2008, 07:04:35 AM »
I will try again. Thanks for the help!!
olf20
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998