Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: olf20 on January 07, 2008, 04:55:21 PM

Title: Trying to upgrade
Post by: olf20 on January 07, 2008, 04:55:21 PM

Hi all!
I downloaded the current lock down release R3.01. When trying to install, the install will stop and give me this error. "Can not continue install because file "dxfreader.ocx" can not be found.
I double checked my Mach3 folder and this file is present. I tried the install / upgrade several times but the same error occurs.
I'm installing this in the same folder / drive that I have always used for prior upgrades.
Any help will be appreciated!
Thanks olf20

Title: Re: Trying to upgrade
Post by: Hood on January 07, 2008, 05:31:00 PM

Not tried it myself but will do so in a few mins, did you try re downloading it from the site just in case you got a corrupt download?
Hood

Title: Re: Trying to upgrade
Post by: Hood on January 07, 2008, 05:37:08 PM

olf20
where are you getting 3.01 from? I only see 3.00 on the downloads page.
Hood

Title: Re: Trying to upgrade
Post by: olf20 on January 07, 2008, 06:10:16 PM

Sorry typo, it is 3.00. I just redownloaded the lockdown version. Tried to reinstall but same error.
Thanks olf20

Title: Re: Trying to upgrade
Post by: Hood on January 07, 2008, 06:19:06 PM

Strange, i have just installed 3 to try again and it works fine.
Hood

Title: Re: Trying to upgrade
Post by: olf20 on January 09, 2008, 07:04:35 AM

I will try again. Thanks for the help!!
olf20