Hello Guest it is December 07, 2024, 10:40:03 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: C rotation  (Read 3275 times)

0 Members and 1 Guest are viewing this topic.

Offline zander

*
  • 2 2
C rotation
« on: January 02, 2008, 03:31:19 PM »
Hello! I would like to cut off circle using C axle rotation table. What shall I configurate Mach3 correct? Could I see process in table display as A axle I could...
Logged

Offline Graham Waterworth

*
  • *
  • 2,747 2,747
  • Yorkshire Dales, England
Re: C rotation
« Reply #1 on: January 02, 2008, 07:39:33 PM »
As far as I know you can only have 4 axis displayed at any one time.

Graham.
Logged
Without engineers the world stops

Offline zander

*
  • 2 2
Re: C rotation
« Reply #2 on: January 03, 2008, 03:59:22 PM »
Ok! So if I correct G Code and insted A360 F100 ... insert C360 F100  in *.tap file I can see no rotation of C axle on the table display.
Alexander

« Last Edit: January 03, 2008, 04:02:13 PM by zander »
Logged
Pages: 1   Go Up
« previous next »