Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: zander on January 02, 2008, 03:31:19 PM

Title: C rotation
Post by: zander on January 02, 2008, 03:31:19 PM

Hello! I would like to cut off circle using C axle rotation table. What shall I configurate Mach3 correct? Could I see process in table display as A axle I could...

Title: Re: C rotation
Post by: Graham Waterworth on January 02, 2008, 07:39:33 PM

As far as I know you can only have 4 axis displayed at any one time.

Graham.

Title: Re: C rotation
Post by: zander on January 03, 2008, 03:59:22 PM

Ok! So if I correct G Code and insted A360 F100 ... insert C360 F100  in *.tap file I can see no rotation of C axle on the table display.
Alexander

(http://photofile.ru/photo/zander/2154073/115281977.jpg)