Hi
This is my first CNC project and I want to use mach 3 to run my x 2 mill, I have built my own controller box keling stepper motors and drivers.
My problem is I cant get the motors to run.
I switch on, the motors energise as I cant turn them.
I have set up the motors correctly as per the video tutorial for setup and trouble shooting.
I had a charge safety pump (cnc4pc) but I have disconnected it.
I have no e stop/limit signals on the diagnostics page.
I have checked my wiring about ten times.
My thoughts are that either the breakout board is not working (cnc4pc - C10) or my laptop controlling it is not working properly.
Another thought is the breakout board is too close to the psu.
Can anyone help please.
Clive