Hello Guest it is January 13, 2025, 02:08:44 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Cool Muscle Motors  (Read 4694 times)

0 Members and 2 Guests are viewing this topic.

Offline Overloaded

*
  • *
  • 4,922 4,922
Cool Muscle Motors
« on: November 16, 2007, 04:37:38 PM »
Hello All,
I am considering using Cool Muscle motors for my project and was wondering if anyone out there has any experience integrating them with Mach3.
Any input would be greatly appreciated.
Thanks
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Cool Muscle Motors
« Reply #1 on: November 16, 2007, 06:04:33 PM »
Just did a quick google for them and it says they can use encoder follower as an input so that, to me, means they can accept step/dir which in turn means they will run fine with Mach if that is the case.
Hood
Logged

Offline Overloaded

*
  • *
  • 4,922 4,922
Re: Cool Muscle Motors
« Reply #2 on: November 16, 2007, 07:51:00 PM »
Thanks Hood,
The driver and encoder is in the motor. Self contained.
I think all I will need is 24VDC power supply and a breakout board.

Any further advise is welcome.
Thanks
Logged
Pages: 1   Go Up
« previous next »