Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Overloaded on November 16, 2007, 04:37:38 PM

Title: Cool Muscle Motors
Post by: Overloaded on November 16, 2007, 04:37:38 PM
Hello All,
I am considering using Cool Muscle motors for my project and was wondering if anyone out there has any experience integrating them with Mach3.
Any input would be greatly appreciated.
Thanks
Title: Re: Cool Muscle Motors
Post by: Hood on November 16, 2007, 06:04:33 PM
Just did a quick google for them and it says they can use encoder follower as an input so that, to me, means they can accept step/dir which in turn means they will run fine with Mach if that is the case.
Hood
Title: Re: Cool Muscle Motors
Post by: Overloaded on November 16, 2007, 07:51:00 PM
Thanks Hood,
The driver and encoder is in the motor. Self contained.
I think all I will need is 24VDC power supply and a breakout board.

Any further advise is welcome.
Thanks