Good morning
I would like to delay the processing after turning on the spindle (m3) to give it time to reach the spindle revolutions. I tried in " config \port and pins\spindle setup\cv delay spin up and cw delay spin down) to insert various values from 1 to 10 but nothing changes
I'll start by saying that I use UC400ETH, Windows XP everything else works fine, is it possible to modify M3, any ideas/suggestions?
any advice is welcome.

time depends on setting in:

Config -> General Config -> General Cinfiguration -> G04 dwell in ms

if this is enabed also "delay spin up" will be in ms

ok, actually in "Config -> General Config -> General Cinfiguration -> G04 dwell in ms" it is enabled, do you recommend disabling it or entering 5000?
thanks for the reply regards

either way is ok.