Hello Guest it is May 25, 2025, 04:43:21 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mach 4 toolpath not smooth in screen  (Read 2870 times)

0 Members and 1 Guest are viewing this topic.

Offline ROTM

*
  • 24 24
Mach 4 toolpath not smooth in screen
« on: July 05, 2023, 06:17:12 PM »
Good day.
I am exporting a file...svg into sheetcam and then export as .tap file to Mach4.
However in Mach 4 screen the toolpaths are not as smooth as in sheetcam.

I just replaced a new PC with a fresh install of Mach4 ...adn on the old pc it was just fine..
Regen does not do anything...also is there a way to make the toolpath lines in the screen a bit thicker?

Thank you!
Logged

Offline smurph

*
  • *
  • 1,574 1,574
  • "That there... that's an RV."
Re: Mach 4 toolpath not smooth in screen
« Reply #1 on: July 07, 2023, 04:41:48 PM »
This has EVERYTHING to do with the OpenGL support in you video card driver.  See if there is an updated driver available for your GPU. 

Steve
Logged

Offline Stuart

*
  • 311 311
Re: Mach 4 toolpath not smooth in screen
« Reply #2 on: July 08, 2023, 02:30:51 AM »
further to Steve's comment

new pc ? I will bet a £ to a pinch of Salt that the new PC has integrated graphics , not a proper GPU

I had the same problem with a Dell opitplex SFF I got a GPU that fitted into the PCI slot and result smooth graphics

Logged
Pages: 1   Go Up
« previous next »