Hello Guest it is February 20, 2024, 11:28:18 PM

Author Topic: can't go towards a direction  (Read 250 times)

0 Members and 1 Guest are viewing this topic.

can't go towards a direction
« on: October 24, 2022, 06:19:06 AM »
Hello
I'm using MACH4, hobby version, in demo mode, with a pokeys57CNC controller. Everything was working fine, until I could only move the axes in one direction. I have the following message : "can't jog in X- direction" (or Y+, or Z+). My Limit/homing switches are in the X-, Y+ and Z+ directions. The homing procedure is yet proceeding normally. When I click on "limits override", I can move the axes in all directions.
Is it a limitation of the demo version ?