Hello
Have an ARF CNC 6040Z Mach3 that was my dad who suddenly passed away.
He had a hard time getting it to work so I wonder if anyone has the RIGHT settings to send to me so I can start over. He had installed Mach3 on a laptop and I have read that PC is to recommend?

Is there anything else I should think about?

Fredrik

So after doing some research you probably have the 6040 with a usb motion control card. If this correct then you first need to install the plugin (RNRMotion.dll) for mach3.I may have my xml from my old setup if you want it to see if you can get something going. that is where I would start.

Hello dude, I have the same question, can someone help to fix this prob?

I can try. What's going on

 You gents still need help?