Hi there i am running Mach3 fully licensed and have change to a new Super USB interface MACH3 100Khz Board 4 Axis Interface Driver Motion Controller recommended by artsoft the trouble i am having is when i run mach 3 in simulation mode it will do thousands of line, when mach 3 is connected to the motion controller it will only do 500 line then stop.

Any help would be good

Pete

You're in demo mode.  Look for your Mach1Lic.dat file and put it in the Mach3 directory.

Hi there i will try that thanks
Pete

Hi there i have a problem with mach3 running on windows 7 64 bit i have a full licence.

I have now installed a motion controller all works ok but it will not go above 500 line

Any help would be good

Hi,

I have now installed a motion controller all works ok but it will not go above 500 line

Then Mach is in Demo mode. You may have a license but it is not in the right folder or corrupt or something.

Craig.

you need to have a valide  licence file

Mach1Lic.dat

in C:\Mach3