Dear Friends I am using Mach 3 v1.98 and I have 8NM Nema 34 Motors.My power supply is 65V and I am using Leadshine microstep drivers , my leadscrew is 5mm/turn.I set up my driver to 800 microstep.
In Motor tuning screen I adjust
160
velocity : 3000 mm
250mm s/s
and pulse time 5
when I move the motor 20 cm then I starts freezing and lose steps.I use Driver test program but I dont know how should it look?
my computer p4 3.0 512 mb ram 256 mb X550 graphic card.