Hello Guest it is August 11, 2020, 02:22:30 PM

Author Topic: Just starting out.  (Read 3056 times)

0 Members and 1 Guest are viewing this topic.

Just starting out.
« on: April 08, 2006, 11:45:34 AM »
I'm a complete newb at this so please bear with me.
I doenloaded the free demo because I wanted to test my hardware. Is there a way I can just the software to test my motors?  I dont have any limit or home switches installed yet.The motors aren't mounted either. Thi is for an X/Y table for a plasma cutter.
thanks
Re: Just starting out.
« Reply #1 on: April 08, 2006, 03:42:44 PM »
Rust all you have to do is set the pins and you can run up to a 1000 line program :) You are not going to need limit switches to get up and running
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com