Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Rusty on April 08, 2006, 11:45:34 AM

Title: Just starting out.
Post by: Rusty on April 08, 2006, 11:45:34 AM

I'm a complete newb at this so please bear with me.
I doenloaded the free demo because I wanted to test my hardware. Is there a way I can just the software to test my motors?  I dont have any limit or home switches installed yet.The motors aren't mounted either. Thi is for an X/Y table for a plasma cutter.
thanks

Title: Re: Just starting out.
Post by: Brian Barker on April 08, 2006, 03:42:44 PM

Rust all you have to do is set the pins and you can run up to a 1000 line program :) You are not going to need limit switches to get up and running