Hello Guest it is May 27, 2024, 12:19:52 AM

Author Topic: Connecting Pokeys57CNC with CNC4PC C4 Charge Pump  (Read 1399 times)

0 Members and 1 Guest are viewing this topic.

Connecting Pokeys57CNC with CNC4PC C4 Charge Pump
« on: October 14, 2021, 03:29:16 AM »
Hi,

I'm looking for confirmation that I understand the wiring between these two units. From what I can see I run a wire from pin 45 on the DB25 connector to Pulse IN terminal on the C4 then from the Pulse OUT terminal on the C4 I run a wire to any of the ground terminals on the DB25 connector.

I would then need to go into the pulse engine status/control settings abd tick the Enable pulse engine, Enable safety charge pump output and make sure it is set at pin 45.

Is this correct?

Thanks
Splint