Hello Guest it is May 27, 2024, 05:01:34 AM

Author Topic: Porelay8 and Mach3  (Read 1398 times)

0 Members and 1 Guest are viewing this topic.

Porelay8 and Mach3
« on: October 21, 2021, 10:41:08 PM »

Anyone had experience setting up a Porelay8 on Mach3? The user manual is helpful to a point but I have not been able to get it functioning.

What I aim to do is to use the relays to control a pneumatic valve set to look after tool changes, coolant, extension and retracting a touch probe and camera.

I did find this https://www.youtube.com/watch?v=eFzRodtRJEc&ab_channel=CNCPRINT but it is in German and for Mach4 and there are some major differences between the menus in Mach 3 and 4. It really starts to look different around the 2 minute 13 seconds mark.