Hello Guest it is January 21, 2022, 10:06:36 PM

Author Topic: Pokeys57CNC and Plasma Sense Out no Z Movement  (Read 157 times)

0 Members and 1 Guest are viewing this topic.

Pokeys57CNC and Plasma Sense Out no Z Movement
« on: June 29, 2021, 06:54:24 AM »
I have built a CNC Plasma table and have everything working fine with the THC turned off. If I turn on the THC I can see Arc ok and Torch up/down signals going to Mach3 but the torch height just doesn't change. Ive followed the guides Polabs provide I`ve even installed a new PC and new software. I`m running a fully licenced version of Mach3. I have created a support ticket with Polabs but they have yet to respond.   If I had hair I would of pulled it out by now.