Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: Lancer1307 on June 29, 2021, 06:54:24 AM

Title: Pokeys57CNC and Plasma Sense Out no Z Movement
Post by: Lancer1307 on June 29, 2021, 06:54:24 AM
I have built a CNC Plasma table and have everything working fine with the THC turned off. If I turn on the THC I can see Arc ok and Torch up/down signals going to Mach3 but the torch height just doesn't change. Ive followed the guides Polabs provide I`ve even installed a new PC and new software. I`m running a fully licenced version of Mach3. I have created a support ticket with Polabs but they have yet to respond.   If I had hair I would of pulled it out by now.