Hello Guest it is March 28, 2024, 12:09:27 PM

Author Topic: Pokey57CNC, Mach3, Proma  (Read 1964 times)

0 Members and 1 Guest are viewing this topic.

Pokey57CNC, Mach3, Proma
« on: May 19, 2021, 03:51:03 PM »
I have seen this asked a few times and searched but I have yet to find a true answer.
Simple Question:
Can the Proma 150 work with Mach3 and and the Pokeys56? Has anyone had success?

Replaced a generic Parallel BOB with Pokey57CNC via Ethernet because my old PC refused to cooperate.
I have everything functioning, can see the Arc OK and Up and Down Signals, but Mach3 does not translate these signals into motion during test mode or while cutting.