Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: JKMotorsports on May 19, 2021, 03:51:03 PM

Title: Pokey57CNC, Mach3, Proma
Post by: JKMotorsports on May 19, 2021, 03:51:03 PM
I have seen this asked a few times and searched but I have yet to find a true answer.
Simple Question:
Can the Proma 150 work with Mach3 and and the Pokeys56? Has anyone had success?

Replaced a generic Parallel BOB with Pokey57CNC via Ethernet because my old PC refused to cooperate.
I have everything functioning, can see the Arc OK and Up and Down Signals, but Mach3 does not translate these signals into motion during test mode or while cutting.