(Not native speaker)
I've been looking for guide how to make Floating Z, THC Plasma working using Mach3 on this forum and i was able to find almost all answers i needed. Community is amazing here. However there are some thing i was not able to figure out just yet.
My goal is to make plasam torch go down touch material (trigger Probe input) move a little bit up, cut shape (during cutting hight of the torch is controled via THC module using voltage), move up, go the the next pont of and repeate the process.
So far I know that I need to generate G-Code using postproces that will generate G31 code. I know that i need to set some things like switch offset, however in generated code G31 commnad is used only once before first cut. What if material is thin and it will get warped because of heat?
What do i need to do for Floating Z to behive like i want? Let's leave THC part for the moment.