Hello Guest it is March 28, 2024, 10:28:28 AM

Author Topic: Mach 3 rapid clearance question  (Read 670 times)

0 Members and 1 Guest are viewing this topic.

Mach 3 rapid clearance question
« on: March 31, 2021, 01:08:59 PM »
Wondering why my rapid clearance dose not always work . It is correct in the G code Z of 1.00 and it always works when i dry run with torch turned off but with torch turned on it drags on the sheet even tho the g code is correct . Any ideas ?

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Mach 3 rapid clearance question
« Reply #1 on: April 03, 2021, 11:37:04 AM »
maybe THC is enabled?
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.