Hello Guest it is April 25, 2024, 03:46:31 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: G codes  (Read 1642 times)

0 Members and 1 Guest are viewing this topic.

Offline Jamwelds

*
  • 2 2
    • View Profile
G codes
« on: March 07, 2021, 12:28:07 AM »
I cannot get g code to load from sheetcam. Files loaded fine until I restarted Mach3, then me jog speed was reduced by approximately 60%, and codes would no longer load.
Logged

Offline TPS

*
  • 2,505 2,505
    • View Profile
Re: G codes
« Reply #1 on: March 07, 2021, 03:11:50 AM »
post your g-code and we will see
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline Jamwelds

*
  • 2 2
    • View Profile
Re: G codes
« Reply #2 on: March 07, 2021, 12:38:17 PM »
N0010 File Name: Acadia Column Base Plat 16 in 2 .tap
N0020 Post Processor: Mach3 THC With scriber (Edited)
N0030 Date 3/6/2021
N0040 G20 Units: Inches
N0050 F1
N0060 G53 G90 G40
NOO70 Part: Acadia Column Base Plate 16in 2
NOO80 G00 XO.0000 Y0.0000
N0090 M04 M30
Logged

Offline Graham Waterworth

*
  • *
  • 2,673 2,673
  • Yorkshire Dales, England
    • View Profile
Re: G codes
« Reply #3 on: March 07, 2021, 09:59:48 PM »
That code has never run on Mach3 or any other system.  The format is all wrong :-

N0010 File Name: Acadia Column Base Plat 16 in 2 .tap - No brackets
N0020 Post Processor: Mach3 THC With scriber (Edited) - No brackets
N0030 Date 3/6/2021 - No brackets
N0040 G20 Units: Inches - No brackets after G20
N0050 F1
N0060 G53 G90 G40
NOO70 Part: Acadia Column Base Plate 16in 2 - No brackets and 'OO' instead of '00'
NOO80 G00 XO.0000 Y0.0000 - 'OO' instead of '00' and 'XO.0000'
N0090 M04 M30
Logged
Without engineers the world stops
Pages: 1   Go Up
« previous next »