I had Mach3 and went to Mach4.
VCarvePro doesn't turn one's designs into a standard Gcode file. It turns them into .txt files for Mach. In Mach3 I copied and pasted into MDI and I could get it to run.
I'm attempting my first carving in Mach4 and it also didn't accept the VCarve file when trying to load Gcode. It mentioned something about some macro failing.
So I tried the copy and paste method of the .txt file into MDI. Nothing happens when I click the cycle start button. I waited quite a while.
With help from this board I was able to home all three axes, and then I moved my spindle to an appropriate place to start the carving and zeroed out all the axes and they were green. The slave axis of A is greyed out but is the last axis shown, and it stays red. Does that matter?
I went to Machine Diagnostics and there was nothing lit up accept the 4 green lights for the four motors.
Any suggestions for this old newbie?