Hello Guest it is October 22, 2021, 02:00:36 AM

Author Topic: Avid CNC tripping breakers?  (Read 257 times)

0 Members and 1 Guest are viewing this topic.

Avid CNC tripping breakers?
« on: November 23, 2020, 06:26:09 PM »
I know there is a good amount of avid cnc guys here so here goes the long shot... Plug and Play nema 34 electronics on a 4'x2' table cut out on me today (loss of power). Every plug I plugged into tripped the breaker. A short somewhere? I wish I new more about electronics but thats all I know so far! Thanks in advance.

Offline Graham Waterworth

  • *
  •  2,394 2,394
  • Yorkshire Dales, England
    • View Profile
Re: Avid CNC tripping breakers?
« Reply #1 on: November 23, 2020, 09:09:20 PM »
Unplug everything in the control that you can, then start plunging back in one at a time and power up, it could be inrush from the system, you may need a type C breaker in the board, A and B are too sensitive on some CNC systems.
Without engineers the world stops