Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jamesfiore30@gmail.com on November 23, 2020, 06:26:09 PM

Title: Avid CNC tripping breakers?
Post by: jamesfiore30@gmail.com on November 23, 2020, 06:26:09 PM

I know there is a good amount of avid cnc guys here so here goes the long shot... Plug and Play nema 34 electronics on a 4'x2' table cut out on me today (loss of power). Every plug I plugged into tripped the breaker. A short somewhere? I wish I new more about electronics but thats all I know so far! Thanks in advance.

Title: Re: Avid CNC tripping breakers?
Post by: Graham Waterworth on November 23, 2020, 09:09:20 PM

Unplug everything in the control that you can, then start plunging back in one at a time and power up, it could be inrush from the system, you may need a type C breaker in the board, A and B are too sensitive on some CNC systems.