Currently my setup wants to use inches/minute for the feed rate, but I want to use actual chip load ( inches/rev)
I tried looking online but have not found anything.
Also, is there a good tutorial video on how to learn the basics of Mach turn?

I have only used a mach3 based mill, and have no clue when it comes to the lathe.
I need to learn the absolute easy stuff that may seem simple for novice users.
Thanks.

G95 is your friend.

Currently my setup wants to use inches/minute for the feed rate, but I want to use actual chip load ( inches/rev)
I tried looking online but have not found anything.
Also, is there a good tutorial video on how to learn the basics of Mach turn?

I have only used a mach3 based mill, and have no clue when it comes to the lathe.
I need to learn the absolute easy stuff that may seem simple for novice users.
Thanks.

useful thread to read
https://www.machsupport.com/forum/index.php?topic=25647.0