Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: hemi43 on September 17, 2020, 12:25:25 PM

Title: How to change feedrate on Mach turn
Post by: hemi43 on September 17, 2020, 12:25:25 PM
Currently my setup wants to use inches/minute for the feed rate, but I want to use actual chip load ( inches/rev)
I tried looking online but have not found anything.
Also, is there a good tutorial video on how to learn the basics of Mach turn?

I have only used a mach3 based mill, and have no clue when it comes to the lathe.
I need to learn the absolute easy stuff that may seem simple for novice users.
Thanks.
Title: Re: How to change feedrate on Mach turn
Post by: TPS on September 17, 2020, 03:00:06 PM
G95 is your friend.
Title: Re: How to change feedrate on Mach turn
Post by: reuelt on September 17, 2020, 06:01:09 PM
Currently my setup wants to use inches/minute for the feed rate, but I want to use actual chip load ( inches/rev)
I tried looking online but have not found anything.
Also, is there a good tutorial video on how to learn the basics of Mach turn?

I have only used a mach3 based mill, and have no clue when it comes to the lathe.
I need to learn the absolute easy stuff that may seem simple for novice users.
Thanks.
useful thread to read
https://www.machsupport.com/forum/index.php?topic=25647.0