Hello everyone,
I am quite new to CNC and am almost ready to fire up my plasma cutter. In familiarizing myself with the table and software, I have found that when I load a G-code into my Mach3 it loads the outside of my work zone. The rectangle is supposed represent my work zone (obviously) but it can very depending on where I have my torch located when I load the G-code. When referenced to zero, the torch is actually outside of the work zone (though, that is less of an issue, I think).
I am using a 5'x10' OEM setup with their custom Mach3 profile.
If there is any resources you think I should look into to become a more proficient CNC user, I would be more than happy to look into it. I just can't afford official training yet ($1200+ a day). I am currently watching the tutorials and am gleaming what I can from them.
Thanks!
Kevin Terral