Hi All,
I put new limit switches in our home built cnc router. They were wired in series but i did it with a separate wire for each switch this time. Each negative line goes to a negative line on the power supply and each common line goes to an input on the Gecko G540 drive. The inputs are no's 2,3, and 4 x, y, z respectively). These are pins no's 11,12 and 13 on the Smart bob. 411. I Made my best guess as to the settings in inputs in Mach 4. When I click home xyz, the z goes to the limit switch, stops and backs off a bit like it should but x and y don't seem to see their switches. They just run into them and crash. I have the switches wired N/O. I double checked the wires and that the switches worked. What should the settings be in Mach 4?
Thank you.