Hello Guest it is June 05, 2023, 01:40:12 AM

Author Topic: Pocket wizard acting strange!  (Read 2740 times)

0 Members and 1 Guest are viewing this topic.

Pocket wizard acting strange!
« on: April 04, 2006, 08:37:38 PM »
I just reloaded my Mach 2 and 3 to my computer after a major crash a few months back. When I run the cirucular pocket wizard, the second set of commands goes crazy. One time it plunged thru the table, the next time it started to just move back and forth on the x axis. I figured at first it was the trial version, but my license is loaded and it tells me I am good to go. Any suggestions greatly appreciated. Thanks in advance.

Re: Pocket wizard acting strange!
« Reply #1 on: April 05, 2006, 10:02:57 AM »
Could you please upload the Gcode file and I will see if there is a problem in the Gcode.
Fixing problems one post at a time ;)