Hello Guest it is September 25, 2023, 12:46:36 PM

Author Topic: Teach Wizard ( Please teach me)  (Read 3707 times)

0 Members and 1 Guest are viewing this topic.

Teach Wizard ( Please teach me)
« on: April 04, 2006, 04:21:00 PM »

Could someone provide some additional details for the procedures necessary to use the teach wizard.
Someone in a forum far far away mentioned that you can just jog the machine to locations on the
table and basically run a piece. How do you enter each location. And is it necessary to know alot of
G-code. Basically I don`t have a clue how to get started with the wizard.

Re: Teach Wizard ( Please teach me)
« Reply #1 on: April 05, 2006, 09:59:18 AM »
I will be making a video of how to use the wizard once I have the new test mill up and running... But for now  there is a thread on there that will show you how to get started.
Check this out:
Fixing problems one post at a time ;)