I redid this morning. Came back with same settings as before.
X & Y
steps- 400
Velocity 3000
Acceleration 425
Material size on file shows as X=10.0 Y=10.0 Z=0.99
Actual cut size is about 3/4 inch square...... 10 inch is about 254 mm so its not just switching to mm somehow
I can manually run table entire width and length. Tried multiple files all run tiny. Machine is set to Inch. Aspire is set to Inch. Files show to be Inch.
Thanks for any help, ideas or things to try
Specs:
6040Z
Dell Optiplex 760
Windows 7 Ultimate
Aspire 10.0
Mach 3 - Ver 3.043.066
G540 Rev 5
Post Processor: Mach3 2/3 arcs (Inch)
Motors-57BYGH433-06BS