Hello Guest it is June 21, 2021, 12:58:29 PM

Author Topic: Cutter compensation not working (Fusion 360 and Mach3)  (Read 255 times)

0 Members and 1 Guest are viewing this topic.

Offline kvid

*
  •  24 24
    • View Profile
Cutter compensation not working (Fusion 360 and Mach3)
« on: February 27, 2020, 12:12:58 PM »
I have tried to implement cutter compensation for a while but never had any luck.

Whatever I do I always get some errors in Mach3.

I made a short recording that goes trough programming a part and importing it into Mach3. I would appreaciate any tips and suggestions.

https://youtu.be/3ZeYL-pW3V8

I attached the g-code and the fusion archive file.

Offline Graham Waterworth

*
  • *
  •  2,326 2,326
  • Yorkshire Dales, England
    • View Profile
Re: Cutter compensation not working (Fusion 360 and Mach3)
« Reply #1 on: February 28, 2020, 10:00:02 AM »
Mach3 needs a lead in and lead out with a line and radius the rad must be tool rad plus a bit and line length has to be tool rad plus a bit so if using a 10mm dia end mill lead in line could be 6mm and rad 6mm then all should be good.
Without engineers the world stops