Hello Guest it is January 28, 2020, 03:33:16 PM

Author Topic: POKEYS57CNC and Mach4 Homing Switches  (Read 96 times)

0 Members and 1 Guest are viewing this topic.

POKEYS57CNC and Mach4 Homing Switches
« on: January 13, 2020, 07:44:56 PM »
Hello All,

I am having difficulty configuring home switches.  I have NC switches wired to the X and Y axis.  They are connected to the Axis 1 and Axis 2 switch locations on the board terminal.  I have tested the switches with a multi-meter and they function as required.

However it seems I am just going around in circles trying to configure them in the POKEYS Plugin and the Mach4 Control Configuration.  I cannot figure out how to complete the configuration.  I've spent time googling and even found reference to the same  type of problem on this forum.

No joy.

Could anyone help me with the steps to configure the home switches?

Much appreciated.

Thanks.
Re: POKEYS57CNC and Mach4 Homing Switches
« Reply #1 on: January 18, 2020, 11:21:58 PM »
Ended up figuring this one out, painful as it was.  On to the next issue!

Offline Tweakie.CNC

*
  • *
  •  8,110 8,110
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: POKEYS57CNC and Mach4 Homing Switches
« Reply #2 on: January 19, 2020, 01:57:01 AM »
 ;)
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.