Hello Guest it is December 06, 2019, 12:46:13 PM

Author Topic: first time user Mach4 on Windows on Mach 3 controller  (Read 151 times)

0 Members and 1 Guest are viewing this topic.

first time user Mach4 on Windows on Mach 3 controller
« on: November 14, 2019, 06:12:05 PM »
Unable to run motors in any mode
Re: first time user Mach4 on Windows on Mach 3 controller
« Reply #1 on: November 14, 2019, 08:34:38 PM »
Hi,
this post should be on the Mach4 General Discussion board, there it will get the most exposure and you will get the most help.

Having said that getting help when you have provided absolutely no information on your installation and setup is going to be hard
to find. Do you log on to the General Motors site and say 'my car doesn't go'....and leave it at that?

The title of your post suggests that you are using a motion controller that worked with Mach3? If so what motion controller?.
You need to be aware that there are about six manufacturers who are producing Mach4 ready motion controllers, without
one of those Mach4 will not work for you.

Craig
My wife left with my best friend...
     and I miss him!
Re: first time user Mach4 on Windows on Mach 3 controller
« Reply #2 on: December 02, 2019, 07:41:00 PM »
I guess he figures we are mind readers?
Retired Master Electrician, Commercial HVAC/R Service and lots of Hobbys.

Offline bestbuymall

*
  •  0 0
  • Online Shopping Mall in Pakistan
    • View Profile
    • Best Buy Mall
Re: first time user Mach4 on Windows on Mach 3 controller
« Reply #3 on: December 03, 2019, 05:17:34 AM »
Mach4 would not be easier than Mach3, but it most likely would be a lot better.

Home Shopping in Bahawalpur


https://bestbuymall.pk/ is an online shopping mall that connects local businesses with buyers, who wish to get products delivered to their doorstep from local merchants.