Hello Guest it is March 29, 2024, 11:16:06 AM

Poll

Mach 4

Mach 4
3 (75%)
Probing
1 (25%)

Total Members Voted: 4

Author Topic: Mach 4  (Read 2782 times)

0 Members and 1 Guest are viewing this topic.

Mach 4
« on: December 31, 2018, 11:34:48 AM »
Make 4 kotz
I'm pretty annoyed right now. That was an expensive experience.
From Mach3 to Mach4 200 € plus new hardware IP-M on new IP-M276€  because the old hardware does not support Mach4. And it is worse than under Mach3. Then you read in the forum, you must also use the latest Versin so Build 4006 installed. And what's even worse, now all axes are simultaneously referencing, no matter what you set. Whether 1 or 2 or 3 or 4 or 0.
Such a crap, that was an expensive experience. Microsoft could not have done that better either.
I'm a little bit nervous.

Translation by google

Best ragards
Torsten
Re: Mach 4
« Reply #1 on: December 31, 2018, 01:04:32 PM »
This Fanuc Paroli is to be offered, but still missing light years.

Best regards
Torsten
Re: Mach 4
« Reply #2 on: December 31, 2018, 01:57:33 PM »
Hi,
CS labs claim that their hardware supports Mach4 but their Mach4 plugin is just plain buggy.

Its a shame you didn't read the forum BEFORE you wasted your money.

Craig
'I enjoy sex at 73.....I live at 71 so its not too far to walk.'
Re: Mach 4
« Reply #3 on: November 25, 2019, 06:09:54 AM »
I'm excited about Mach4. However, a training period is necessary. It is not easy. But possible.